SO-DO Kamen Rider Zero-One (and Zero-Two) hands
Description
These hands were made for the SO-DO Kamen Rider figure line, which are 1:18 scale. These hands in particular are for the standard SO-DO pegholes, used from Ex-Aid to Zero-One. My hands provide a balljoint rather than a peg, adding a nuance to the poses you can do. This hand uses the Zero-One armor design, so it is made to go with the following figures: - Kamen Rider Zero-One - Kamen Rider Thouser - Kamen Rider Ark-Zero - Kamen Rider Eden Also, there's a particular pair of hands for Zero-Two, in relation to the 2020 winter movie. The files included: - zeroone-curl - A calm hand pose used for certain Zero-One poses. - zeroone-fist - A clenched fist without an item peghole. - zeroone-item - Item-holding hands with a 3mm peghole. - zeroone-open - Standard SO-DO style open hands. - zeroone-pointin - A point for Zero-One's catchphrase. - zeroone-pointout - A point for when Zero-One makes a pun. - zeroone-signature - A hand for a particular Zero-One pose. - zeroone-thumb - A thumbs up for Zero-One's catchphrase. - zerotwo-spoiler - If you know, you know. In my case, I used a Flashforge Finder Lite to print these in PLA, but the small size means you're better off using a resin approach. Models have been positioned for you. Support needed on all files. SO-DO uses different peghole sizes for the left and right, so these are not made to be mirrored.
Statistics
Likes
0
Downloads
0