ZMR 250 Spacer Kit , Tilted Motor Mounts
Description
More Information On My Original Thread On Rc Groups, : Http://Www.Rcgroups.Com/Forums/Showthread.Php?T=2256768 Frame Spacer Kit : - 7Mm Spacer (4) - 10.3 Mm Clearance Between Lower & Upper Frame - Requires M3 20Mm Bolts, I Only Use 2 Per Arm, Strong Enough. Led Holder : - 10.3Mm Led Holder (2) - Use Any Led Strip With A Maximum Of 10Mm Height - Mounting Either With Double-Sided Tape Or Hotglue / Ca From Hobbyking - There Is Also A Simplified Version Available, Without Overhangs, And The Groove Has Been Removed, For Easy Printing. I Use The Turnigy High Density R/C Led Flexible Strip From Hobbyking, They Are 8Mm In Height 10° Tilted Motor Mounts : - They Are Labeled With F (Front) And R (Rear). - Calibrate Your Naze While Level, Then Add 10° Pitch Offset Via Cli : Align_Board_Pitch = -10 - 1806 And 2204 Motors Supported. - Because Of The Angle, You Might Have To Slightly Enlarge The Holes On The Arms.
Statistics
Likes
138
Downloads
0