Lightsaber Wallmount
Description
This is a universal wallmounting system for Lightsabers with a 2.54cm (1 inch) blade. The holder itself is printed best upright to ensure the holderclamps dont break. For the logo i recommend printing it flat on the bed with Ironing (in Cura for example) enabled. This way to logo comes out smoothly. There are 2 notches on the back of the holder to glue in place the logo if you wish so. But it is not needed to function. As glue i just used superglue. Hotglue may not work due to forming a gap between the two parts. The two holes are 3mm in diameter and are countersunk to ensure flush mounting. I've used wall anchors since my house is very old.
Statistics
Likes
7
Downloads
0