Easy Print 10mm Wide LED Strip Holder for Tight LEDs
Description
Please give me a like up top if you think this project is useful, and I'd love to read your feedback in the comments if it helps you out or needs improvement. *** I ran across [lhendri1](https://www.thingiverse.com/lhendri1/designs)'s tight LED strip holder when I was starting to learn Tinkercad a few months ago, and took a shot at remixing it to print without supports. After a few hours of hyper focused grinding at the learning curve... It works! Of course, you can use them for any led strip 10mm or less, and I did. They are holding up a few strips in my hobby shed. I printed these in PETG with 100% infill to handle a screw head tightening down on them. I think PLA would crack if your like me, and have a hard time with the definition of "snug".
Statistics
Likes
48
Downloads
0