Lack Enclosure height increased support and bigger filament feeder hole
Description
As i print ASA and the smell gets too my wife, i decided to make an enclosure using the files found on Thingiverse, However, I not only have rubber feet on my Ender 3, but also dual Z and the Z-rods are about 3mm from the top of the enclosure. I also made the support so as it not only went around the leg, but also extended to the top of the table. I noticed that the filament feeder hole was also too small to sit all of the way down on the table top so extended it so as it would fit snug and go all the way down.
Statistics
Likes
1
Downloads
0