Customizable Logistics Platform and Anchor (CuLPA) Base Files
Description
This platform idea was originally generated by https://www.thingiverse.com/pseudo6626/ CuLPA is a basic platform allowing the easy swap of extruder and hotend combinations on the Artillery Sidewinder (probably also works on Genius without any modification, untested!) The PCB and ribbon cable connection is a good advantage because you simply need to disconnect that ribbon cable and you are good to go. Unlock the CuLPA sled from the backplate and swap in your alternative extruder and hotend. With this setup I created a sled variant for the Orbiter extruder with a Mosquito clone hotend and running a 5015 partcooling fan (made by: https://cults3d.com/en/3d-model/tool/5015-artillery-sidewinder-x1-dragon-mosquito-volcano-combo-duct). You will need heatset inserts (I used M3x4x5 mm), some M3 bolts and an M3 T-nut. Print with ABS or even better material if you plan to use high bed temps. My currently used highest temp on the bed is 110 °C and 260 on the extruder. The ABS holds up good but I feel like it is on the border. If you only print lower temps you could certainly use PETG aswell. note: yes, I know I need to tune my support interfaces :)
Statistics
Likes
6
Downloads
0