CR10s Pro V2 Direct drive bracket - DMD
Description
This is a bracket that I designed to fit on a stock CR-10s Pro V2, using the stock extruder and stepper motor. I bought a "Stepper Motor Extension Cable (43cm)" to accommodate the new location: https://3dprintingcanada.com/products/stepper-motor-extension-cable-43cm I left a small length of filament in the filament sensor since I don't use it anymore. I remixed the Creality CR10s Pro Extended fan shroud (40x20mm fan) by plammers (https://www.thingiverse.com/thing:4814295) and my bracket is a perfect fit with it. *** You can use the stock one. Just use some washers/spacers to fill the gap ***
Statistics
Likes
20
Downloads
0