Enclosure for 3x7 cm project board
Description
I designed this little box as I was frustrated with the commercially available, "one size fits nothing" enclosures for electronics projects. This one works quite well for the made in Shenzen type of PCB's, along with a very snug fit lid. I did not place holes to mount the board inside, instead leaving it up for the user to drill an appropriate pilot hole at these locations. I also included posts on the inside for the user to drill pilot holes to fasten the lid to the box if so desired. My filament of choice is PLA, but should work for any filament or resin media 4/6/2021 Revised the box design to fuse the screw pillars to the inside of the box.
Statistics
Likes
0
Downloads
0