Ender 3 Filament Guide (no slot)
Description
This is a remix of ElevationsTech (https://www.thingiverse.com/thing:3950799) filament guide for the Ender 3/Ender 3 Pro. At first the idea of a slot seemed great (you don't need to unload that first roll of filament), but it ended up causing me a lot of issues. Quite often the filament would pop-out through the slot when printing and cause a gangly mess - do note that I am using bearing equipped filament rollers, so rolling friction is quite low. I am aware there were some revisions that made the slot smaller (and perhaps there's a remix that has no slot that I overlooked), but nothing I saw quite floated my boat. Behold the completely un-original slot-less design. It's based off V3 of the remix origin, and yes I am aware that V1 had no slot. Just figured there may be a few people who may want the V3 design but without the slot, so, here it is. If you do want a slot, but you're having the same issues as I with the original V3 design, check out this other remix by doppel_strayr (https://www.thingiverse.com/thing:4742888).
Statistics
Likes
8
Downloads
0