Snapmaker 2.0 Alignment Anschlag CNC
Description
Snapmaker 2.0 has no fixed Zero Point for machining For alignment I created a very simple 160x160 90° angle which is fixed by up to 7x M4x14 Screws in the worktop nuts, used for CNC-carving. You can leave screw-holes unattended to use the nuts in the table for fixture of your working piece. Distance between the 4,2mm holes is middle to middle 50mm as given from the worktop. Hight is about 3mm, maybe it should be a bit higher, but to prevent the toolhead and the tool to crash into the screws I decided to let it more flat. For alignment this will work well enough. As you can not use the hole worktop, the alignment is NOT Machine Zero in X and Y. In case of performing a cut, the machine starts by center of workpiece - the advantage is to be able to re perform one cut several times (in reference or) in the same place of your workpiece.
Statistics
Likes
6
Downloads
0