TENLOG D3pro - linear guides on the Z axis
Description
necessary material: 2 x 400mm MGN9H (in photo 450mm cut to 420mm) M3x8 and M3 Tnut nuts assembly instructions: mount the adapter on the trolley (M3x8) and prepare the M3 screws / nuts (in the photo: adapter designed for LED light support) disconnect the VGA, X motors and X endstop cables remove the GT2 belts (precautionary, not mandatory) disassemble the X axis by removing the 4 screws (photo 1) remove the outer wheels and replace with the spacer (reuse M5 screws) NOTE: It is important to start with the outer wheels remove the internal wheel and position the linear guide in the center of the profile (use tool2040) make sure that the linear guide reaches the top of the upright (see photo 2) fix the adapter to the X axis (reuse the M5 screw) repeat the operation on the other side reassemble the X axis and reconnect the cables Note: the machine uses marlin2. system NOT tested with Tenlog firmware (different homeZ procedure) compatible version with LED support. link: https://www.thingiverse.com/thing:4818192
Statistics
Likes
3
Downloads
0