Barad-Dur Dice Tower (Eye of Sauron)
Description
Barad-Dur Dice tower (Eye of Sauron) from Lord of the Rings. Slot in the back for a die to slide down. slide lets out into the flat chamber and rolls the die, protected so no dice roll off the table. I printed it in 8 pieces to create the inner slot without any issues and so that minimal support/scaffolding would touch the shown faces, instructions below: Part 1 and 2, the base: print oriented normally, no support needed. Part 3 and 4, the second section up: print oriented normally. no support needed if you can bridge the arches, otherwise use support Part 5, the third section up: print oriented upside-down. this will prevent the need for support on the sharp, downward-facing features Part 6 and 7, The top, the Eye of Sauron: print each half radially inward side down so no support material is needed the .stl of the full model is also available if you have a different printing strategy, or if you think you can print it all in one go. Follow me on Instagram to see the tower in action: https://www.instagram.com/p/B-ak0ovBctj/
Statistics
Likes
54
Downloads
0