Landing Gear suitable for Eclipson Model T
Description
Created this for the free version of the Eclipson Model T airplane as I am not good at hand launching :) im using 2mm pushrods to hold the wheels. (2mm holes already in this for the wire which can be enlarged if required) I printed it upside down (wheels upwards) using tree supports to get a decent finish 0.16mm layer height 0.4mm line width 3 walls 30% infil 20% supports 0.16mm floor zgap 0.32mm roof zgap 3 layers support interface at 90%
Statistics
Likes
1
Downloads
0