Anycubic Photon to Photon Mono Conversion
Description
This is a two piece set to convert your original Anycubic Photon to the neck and baseplate adapter used in the photon mono. The photon mono uses an easy and in my opinion, more stable leveling and fixturing system of four set screws to lock the build plate into the precise angle during leveling. These parts can be printed on FDM or SLA printers. The pieces are attached to the photon neck and baseplate with the screws that come from the original setup. The only additional hardware you will need is the list below: - 4 M3 x 20mm countersunk screws - 4 M3 x 4mm x 5mm threaded inserts If printing on FDM, I recommend 100% infill to give the pieces the rigidity needed under when tightening. Depending on the dimensional accuracy of your printer, you may need to do some light sanding/filing on the surfaces that rub against each other to make them smooth.
Statistics
Likes
8
Downloads
0