Satsana Fan Mount Ender 3v2 with 5015 Fan Channel
Description
Update-- added fan guard. use 2 23-25mm m3 screws to secure. Make sure to either drill out or tap the holes in the fan guard, and tap the holes in the fan duct for a proper fit. Remixed version of https://www.thingiverse.com/thing:4647053 by scrath, which was in turn remixed from the original satsana fan duct. Cable clip for this can be found here, but I have not tested it yet. The original version didnt properly fit a 5015 fan without using tape to seal it in, so I made a quick remix in tinkercad. This can be secured with 2 25mm M3 bolts and nuts, and there should be enough length on the screws to add a cover to the top screw to cover the hotend fan. Hotend fan is secured with the 2 original Ender screws. I printed this with no supports with fairly good results. There was some bad layer adhesion in some corners of the fan channel that could be easily cleaned up with a hobby knife. Some modification may be required to get hinges on your fan to hit. I took 30 seconds with a file to get an appropriate fit. Otherwise, your fan should slip right in. Blower Fan used: https://www.amazon.com/gp/product/B07DB7DLMM/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1 Hotend fan: https://www.amazon.com/Noctua-Cooling-Blades-Bearing-NF-A4x10/dp/B009NQLT0M/ref=sr_1_2?dchild=1&keywords=noctua+4010&qid=1618080602&s=electronics&sr=1-2
Statistics
Likes
31
Downloads
0