Gimbal Protector for DJI FPV Remote Controller 2
Description
This is a gimbal protector for the DJI FPV Remote Controller 2. The gimbal cones are a loose slip fit (9mm) and the protector is held in place by a friction fit to the lanyard eyelet. This fit may be a bit loose or tight depending on your printer and settings, so please leave feedback and I can spin up a couple more versions. There are radii on the bottom of the gimbal cones so that they tend to self-center if pressed down. Inspired by a number of similar designs I've seen here on Thingiverse and eBay, but all of which either didn't stay reliably in place or required a velcro strap to hold in place. Always shooting for 100% printable parts! If you're looking for a solution to hold the battery for your DJI FPV goggles, check out my design here: https://www.thingiverse.com/thing:4837759 Here is the DJI part: https://store.dji.com/product/dji-fpv-remote-controller-2
Statistics
Likes
33
Downloads
0