Arrma Granite Big Rock 3S BLX TPU Wing Mount
Description
This is an improved version of the [Arrma Granite 3S BLX v2 TPU Wing Mount](https://www.thingiverse.com/thing:4802854) I remixed. The differences are : * Tougher support (because I broke the previous one on a bad landing) * Needs shorter screws * Has dedicated holes to insert nuts under the wing * I pushed the wing back by 4mm because it was to close to the body for some I tested it on an Arrma Granite 3S BLX V2 and a Arrma Big Rock 3S BLX V3. It should fit any Granite or Big Rock of any generation. Materials required for wing mount assembly is: * 3 x M3x12mm screws * 5 x M3 locknuts * 3 x M3 washers (used under the M3 locknuts, optional but recommended) I hope this will help someone. It helped me at least. __Note: Photos show a print with TPE filament that retracted itself a little during the print, that's why the two parts are not perfectly stuck. It works perfectly though. Your print should be much better than mine, once again :).__
Statistics
Likes
8
Downloads
0