Little Planter
Description
<b>Hello Thingiverse,</b> I just created this little planter that I want to show you. The model includes two pots. One is the inner and the other one the outer pot. So you can plant your plants into the inner pot and too much water can flow through the holes inside the outer pot. For this little Planter you just need <b>three 8 mm wooden rods</b>. Minimum length will be around 11 cm, but I strongly recommend to use longer rods as it will look much better. <b>I used 17cm wooden rods </b>but you can increase the length as you like :) You can print both pots <b>without any support</b>. Print the inner pot on the flat bottom and the outer pot upside down. This will work just fine! I recommend to use a wall thickness of 1,2 mm for the outer pot to achieve a nice feeling and get it tight. <b>Enjoy!</b>
Statistics
Likes
3463
Downloads
0