Organic Tweel
Description
This is a light weight organic structured airless tire (Tweel) similar to that of a sponge it is intended for dual extrusion but could be printed all in TPU with high enough infill to prevent the Hub from flexing. **Settings:** **Print Setting (Hub):** Material Used...................**PLA** Layer Height ...................0.2 mm Wall Thickness.................0.8mm Printer Used ................... Raise3D E2 Extruder/Bed Temp..........210/60 Top/Bottom Thickness.....0.8mm Mass ................... ...........48grams Combined Print time ................... .... 517 min Combined Infill Density................... .15% **Print Setting (Tire):** Material Used...................**TPU** Layer Height ................... 0.2 mm Wall Thickness.................0.8mm Printer Used ................... Raise3D E2 Extruder/Bed Temp..........235/60 Top/Bottom Thickness......0.8mm Mass................... ............48grams combined Print time................... ......517 min combined Infill Density................... ..10% **Print Notes:** *No Supports are needed* It is designed for dual extrusion, if printed separately the Hub may not stay in the Tweel. *The hub and Tweel could be printed all together in **TPU** with the hub set to higher infill as an alternative to dual extrusion so they can still fuse together **if you want to design your own organic structured 3d model you can load your STLs into *www.voronator.com* which applies a filter, it converting it to an organic mesh.**
Statistics
Likes
0
Downloads
0