Pixel Spinner Remix for Brick Mount and Prusa Mini
Description
I remixed the pixel spinner to allow for a the middle to be mounted to the brick via a couple concrete anchors and screws. I separated the two pieces so that it would be easier to print without as many supports. You can glue together, or leave apart since they should not come apart due to gravity. I also remixed the 5 in spinner and doubled it to make almost a 16" arm. I combined with a dovetail joint and for added strength I added a bolt hole through the dovetail for a M3 x 16 bolt and nut. Basically did this because I wanted a larger spinner but I have a Prusa Mini+ with only a 180x180 print bed.
Statistics
Likes
1
Downloads
0