Cooler Master MB530P mesh front panel
Description
**Mesh front panel for Cooler Master MB530P computer case. It's magnetically attached and doesn't require any permanent case modification.** ##### Parts required: ##### - 4 screws to hold to the magnets - I used Flat head M3x5mm hard drive mounting screws - 8 10x2mm round magnets - I had these already, but anything 8-12mm diameter around 4mm thick should work - Epoxy or CA glue to join the pieces together - Suitable mesh to sandwich between the halves https://www.amazon.com.au/gp/product/B07H31FZ92/ ##### Notes: ##### - If you don't want to use magnets, the screws that hold the glass panel in also work with this design - The panels have been split to fit on a 200mm print bed - The magnet holders should be a tight fit on the spigots for the original glass screw holes so glue isn't required - The screw holes on the outer panel are undersized and need to be drilled out - Print Outer Panel Top with supports for the overhang at the join - Sandwich the mesh between the inner and outer panel and glue it all together
Statistics
Likes
6
Downloads
0