DUSTAN WEBB
Description
I designed a stand/base for a lithophane I wanted to print. This is specifically made to fit a 200mm "outer curve" with a 5mm border and 3mm thick Lithophane designed at https://3dp.rocks/lithophane/ The base uses an E12 candelabra socket Like in the pictures (the link I purchased from) https://www.amazon.com/gp/product/B07WR6HCPQ/ref=ppx_yo_dt_b_asin_image_o04_s00?ie=UTF8&psc=1 Just assemble the Lamp socket and screw it in to the base from the bottom until the bottom is flush with the wire clamp hole, then use the shade nut to lock it into position. Then bend your wire out the back and install the wire clamp using 2 x 4-40 socket head cap screws. I've included an stl for test fitting your lithophane, just print about 5 mm of your litho check with this.
Statistics
Likes
4
Downloads
0