Dremel hobby paint shaker
Description
A paintshaker for hobby paints i.e citadel, army builder etc. Didn't find one for a dremel tool so made one. Uses a R188 bearing, the cam shaft is a sanding drum shaft and the front reciprocating shaft is a cutting disc shaft. These both are very usual dremel bits and come cheap from stores. The cam holes usually come out a bit undersized, so going through with a 3.2mm drill bit is recommended. Shafts and bearing should be super glued in place, so use parts you can get rid of and be careful not to glue the bearing shut. The shaker is fairly loud, but does it's job wonderfully. I recommend printing the cam with 100% infill, the rest at about 40%-60%. All printed at .2 layer height.
Statistics
Likes
23
Downloads
0