Ender 5 Plus Case Electronics Tray for Raspberry Pi 4 and Buck Converters
Description
Purpose: - Mount the Pi 4 and a few buck converters in the stock case Note: - Designed to fit alongside the Meanwell RSP-500-24 PSU using the mounting adapters I made up - I also drilled matching holes on the opposite side of the case for extra support - Tray mounts to PSU and all slides in together - Pi MUST, MUST be powered via the GPIO (pin #1 for POSITIVE and pin #3 for ground BUT check a GPIO diagram yourself) - If you wish to run your USB-C cable to GPIO you'll need to use a USB-C breakout so a handshake can take place and allow power to flow. Unlike USB-A you can't just snip the end and take the feed directly
Statistics
Likes
5
Downloads
0