Graflex Stand
Description
This is a Displaystand for your Graflex Lightsaber. I printed it in Anycubic Black PLA in 0.16mm Layerheight. It took about 27 hours that way but it turned out great. The Aurebesh letters say "Graflex" as you could have guessed. i printed it laying on its "back" with the Tree supports in Cura. That way i can print the holderarms without support and only have to support the top of the letters. The print is rather PLA consuming so check your settings properly before printing. Mine was using about ~350 grams of PLA
Statistics
Likes
6
Downloads
0