Wall-mounted Siva Logo Lamp
Description
This wall mounted Siva logo lamp is my contribution to Season of the Plague. For more information on the fan project and a ton of amazing siva themed stuff visit the official Season of the Plague twitter account: https://twitter.com/SeasonThePlague ## **What you need to make your own lamp:** - A good amount of black filament for the front and back shell - Some transparent red filament for the diffusor - One of these battery powered LED strips: https://www.amazon.de/dp/B08FDTF88D/ref=cm_sw_r_tw_dp_Z4M1CTPGGB24K7EFJWCX - Aluminium foil or reflective tape - Glue or tape of your choice - Two (at least) 50mm long Nails with a head diameter of less than 9mm ## **How to print the parts:** - Diffusor Rotate the model in your slicer so it is flat against the print surface and print it solid - Front shell Rotate so the logo is facing the print surface and print solid as well - Back shell Rotate so the holes for the nails are facing the print surface and print with about 10% infill This model does not need any supports, bridging is your friend here! ## **Assembly:** - With the glue/tape of your choice stick the diffusor to the back of the front shell - Stick a good amount of aluminium foil or reflective tape to the top side of the back shell to reflect the light from the LEDs - Guide the LED strip through the hole in the back shell and stick it to the top side wall in a circle - Stick the LED strip's battery pack to the wall-facing side of the back shell - Slide the front shell over the back shell ## **Notes:** - The holes for the nails are 90mm apart - When putting the nails into your wall, make sure to let them stick out a bit so you can use the push button on the battery pack to turn the lamp on or off by pressing the whole thing against the wall a little
Statistics
Likes
6
Downloads
0