DIY egg tumber
Description
Used a 4cm syphon tube as the enclosure with a air stone at the top. Printed in pla at .2mm layer height and 80% infill. Print the "malla" file twice. One goes on top so fish cant get out through the hole at the top. And one at the bottom to create a bigger gap between the outside fish and the inside ones. The "tapa" is an end cap that goes at the very bottom to seal. Se utilizó un tubo de sifón como el cuerpo, con una piedra aeradora en la parte superior. Impreso en pla a .2mm con un relleno de 80%. Imprime el archivo de "malla" dos veces, uno va en la parte superior para que no se salgan por arriba. La otra en la parte inferior para crear un espacio mayor entre los peces de afuera y los de adentro. La tapa va mero abajo para sellar todo. Video en epañol de como se armó: https://www.youtube.com/watch?v=Nhj6rvrUcvI
Statistics
Likes
3
Downloads
0