K2 Raider Pro Inline Skate break spacer
Description
Two of my kids own the K2 Raider Pro inline skates. Both are doing a lot of tricks with it. If you do tricks with inline skates like driving backwards the brake are a risk for accidents. Because of this I decided to dismantle the break. The screws are too long after the break was gone. This is the point where the spacers come in. Because I do not want to make one spacer for one side of the screw, I decided to do two spacers for each site of the screw and the nut. You need two prints two of the k2_brake_spacer. Put one to the site of the nut and one to the site of the screw. Tighten up the screw and there is no wobble in the wheel left.
Statistics
Likes
2
Downloads
0