Front Side Cable Chain Mounts for Hydra Fan and Hotend Mount for Creality Ender X Gantry
Description
Connect your Hydra hotend cables to your Ender 3 X drive box with this chain setup. You'll need slightly longer M3 bolts, approximately 25mm to use the overlay version that just mounts over the existing box. * This design includes clips to allow you to re-close your chains without having to feed wires through it. They are friction fit. I considered using Voron zip chains for the same concept but I like these better so far, no waste when you need to reopen it. I'm using a smaller creality z-axis motor to drive my extruder, you may need to clip off the guide tab if yours is much bigger. * I'm including another (untested) version that includes the whole box (minus the endstop mount) for those who want to reuse their stock screws. Apparently it can be hot-glued to the right spot, though I would hesitate to do so personally.
Statistics
Likes
2
Downloads
0