Resin printer length bridge test 1 to 18mm wide
Description
Designed this to test out different resin bridge properties. With the settings I used it took about an hour and a half or so to finish. Not sure if it would work for FDM printers, but go ahead and try it! Wall thickness of bridges is 1mm. Tested so far Siraya Tech blu. Surprisingly it will complete a bridge even up to 18mm, however the layers separate since the initial bridge layer has nothing to hold on to and it's only .05 mm thick it doesn't stay tight. Tested: Siraya Tech blu used 3.3 sec exposure time, 30 sec bottom exposure time, 10 bottom layers
Statistics
Likes
2
Downloads
0