BedLevelCheck or HowToFix A WarpedBed
Description
#*ATTENTION!!! WORKS ONLY ON FLAT BEDS!!!!* Use .stl *only* if you KNOW your bed is flat. If your bed is heavily warped-> fix it first or buy a new one and hope for the best. *You'll find a solution for your warped bed down in the notes* How to use this; 1st step; *Coarse* -> Level Bed with paper/post-it. Check corners ~30mm from edges and once up/down left/right through the middle (at this point you should notice if your bed is flat or not. Stop here if you feel that the nozzle sometimes scratches/no resistance.) 2nd step;*Slice* -> *200mmSquare_0.5mm.stl* with your favorite slicer-software to *0.2mm* Layer Height with *20mm/s* printspeed and your preferred *temperature settings* 3rd step; *Fine* -> Print *200mmSquare_0.5mm.stl* on your printer, while carefully observing the nozzle. Adjust the sides or single corners where the; Filament *curls (the nozzle is too far from bed and therefore does not stick -> raise the bed)* or Nozzle *extrudes wide,flat layers or does not extrude (the nozzle is too close to the bed -> lower the bed)* Stop print after first 2 laps 4th step; *Repeat 3rd step until satisfied or print something awesome if you already are* There it is... my first upload xD you can laugh now, or when you saw my cad-skill-level from the attached file................. no stop...pleasePLEASE
Statistics
Likes
2
Downloads
0