Adjustable picatinny sights
Description
Iron sight pack made by u/AyyLmaoSinceDayyLmao Parts/tools you will need to complete the sights: 5x M5X30 screws 5x M5 lock nuts a small flathead screwdriver Optional: Drill Xacto knife Sandpaper Tips: 1. Print everything in the orientation from the STLs. EXEPT the SIG rear sight housing, it can be printed lying down to reduce support material and increase strength. 2. Print front sights, front sight posts, and rear sights with a .12 layer height because threading needs a higher resolution. 3. Use supports touching the buildplate. 4. The front sights need supports everywhere with an overhang angle of 80 degrees. 5. Use a small screwdriver to screw in the front sight post with the elevation knob in place. 6. If the front sight is tight, keep screwing it until its loose. (You should be able to adjust the front sight post with your fingers) I used PLA+ but you can use whatever you want.
Statistics
Likes
32
Downloads
0