Anycubic Mega Zero X-axis clamp mount (for PiCam and more)
Description
I made a clip for the left side of the X-Axis of an Anycubic Mega Zero printer. The .stl does NOT have the Pi-Cam holder already attached, because the one I used has a no-remix license. But now you can choose based on your camera module. For me, it was this one: https://www.thingiverse.com/thing:2886101 This design went through many iterations of printing it, trying it out and going back to the drawing board. Now that it finally works, I'm happy to share it! You can basically use any other Model and attach it to the bottom of the clip (too far up and it will hit the hot end on homing). It's strong enough to support almost anything, that is not moving on its own and is applying forces on the horizontal axis (bending the clip open). To attach it you don't need any tools or screws. Just slide it on from the left side and push it down until it clicks into place. Be careful not to break it while doing so. It sits at a slight angle downwards when it is correctly installed. Keep that in mind while attaching stuff. The rounded top edge is there to make the belt-end not getting scratched on homing. While printing they do not hit anyways. Also the back side of the notch to hold the clip in place is smaller than the front one to enable attachment without disassembly of the Printer. I'd love to see attachments to this uploaded as remixes!
Statistics
Likes
2
Downloads
0