Fiamma Aqua Pump 8 Piston - Remix with FreeCAD Files
Description
# Introduction This is a remix from the great model of win and *thing:2455364* I recreate their model in FreeCAD and added the original file for those who need to change some dimensions. I printed it in white PETG at 100% infill, and it works like a charm! <br> # Print tips My recommendation is to print them one by one, as you need to ensure a good print without blobs or artifacts. Double-check your print in order to avoid installing a bad part as you can clog your pump and it will leak the water all over the place! Best to use a glass bed in order to get the bottom of the part as flat as possible. <br> # Installation Use an electric screwdriver and try to screw it as straight as you can. It should be tight, but the piece should be able to move up and down in order to function properly. Once it is installed, check for any unwanted noise from the pump or inconsistent water flow, as it might be a problem with the tightening of the screws. If everything goes right you should be able to use your water pump again without a problem. Hope you like it.
Statistics
Likes
5
Downloads
0