Yet another stackable planter
Description
This is yet another stackable planter set. Each layer have a small water reserve making the watering easier and more efficient, and the water communication hole between an element and the element below is eccentric so that the water doesn't dig a fast tunnel between one layer and the other after some time. The pieces of the set snaps-in one into the other so that you can achieve the height you need. There are 3 types of elements : - Footer (Pied.stl) : ring part is designed to accept 25mm electric tube as feets ; their length must be adjusted to the height of the planter for good stability. I use 15cm lenght for a 5 stage planter. Caps to nicely close the tubes are included (Bouchon.stl) - Spacers : small (Spacer bas.stl) of high (Spacer haut.stl) to give more space to your plants, shall they require it - Planters themselves, in two height too: small (Corps bas v3.stl) or high (Corps haut v3.stl) to be stacked depending on the space needed by your plants Everything is compabible, you can mix as many elements as needed. Does not require support, except the Pied.stl. Diameter of the planter is 220mm to fit on the anycubic kossel print area.
Statistics
Likes
80
Downloads
0