Flow Calibration Cube
Description
<h2>The design files and instructions have been moved here:<br><br> <a href=https://www.prusaprinters.org/prints/81314-flow-calibration-cube>Flow Calibration Cube</a></h2> Update May 11, 2021 I've added flow calibration cubes for the following nozzle sizes: 0.20 mm, 0.25 mm, 0.30 mm, 0.40 mm, 0.50 mm, 0.60 mm, 0.80 mm, 1.00 mm. See How-To below. About One of the most important things for good quality prints is to get the flowrate / extrusion multiplier correct for your filament. Good news is that's it's easy to dial in. How-To, 0.40 mm nozzle For example, using a 0.40 mm nozzle, set the line width to exactly 0.40 mm in your slicer and print this calibration cube which has 0.80 mm walls. After you have printed it, measure the thickness of all four walls with a caliper and take a note of the widths. For example, let's say these are the widths of the walls measured: 0.81, 0.82, 0.83, 0.83 Then the formula to calculate the flow rate is: 0.80 / ((0.81 + 0.82 + 0.83 + 0.83) / 4) ≈ 0.97 So, the flowrate or extrusion multiplier is about 97% or 0.97 which you then set in your slicer. Print the cube again to confirm. The measured walls should now be very close to 0.80 mm thick. What about other nozzle size? The formula is the same for the other nozzle sizes. Set the line width to be exactly the same as your nozzle size then print that specific flow calibration cube. Then measure all walls with a caliper. Here's the formula to calculate the flow rate: (Nozzle size* 2) / ((Wall 1 width + Wall 2 width + Wall 3 width + Wall 4 width) / 4) Notes: You can use a brim to increase bed adhesion if you like.
Statistics
Likes
97
Downloads
0