TronXY X5S Direct Drive Titan Mount + Stabilized X-Carriage + BLTouch
Description
So after much hunting, I finally found a decent mount for a Titan extruder for my X5S, with a very clever BLTouch mount. However, it had a few design flaws, so I remixed it! I found that with the extruder mounted, you couldn't adjust the tension. Also, I liked the stabilized, tensionable x-carriage, but it would also interfere. Thus, this was born. I used Wings3D to extract the motor mount from jebk's design, then modelled a new base in Fusion360 to attach to the x-carriage, and finally used 3D Builder to combine the two pieces. Also chopped the cable chain mount off the x-carriage, which is why it's here. Needs a tiny bit of support on the bottom part of the carriage, but everything else can be printed support-free. Note: The original x-carriage I used is here: https://www.thingiverse.com/thing:2895589
Statistics
Likes
2
Downloads
0