ASK13
Description
This is a *static model* of the popular training glider ASK13. The model comes in two ready to use bluid plate. If the outer wing part is too difficult to print straight up, it might be a good idea to print it flat. Printed just fine on my Ender 3 with 0.16mm PLA layers, after a slicing done with PusaSlicer. No raft or brim used, these would probably be a pain to remove ^^ You may also want to have a look a my [Janus C](https://www.thingiverse.com/thing:4824557), my [JS3](https://www.thingiverse.com/thing:5138871) and my [Ka6e](https://www.thingiverse.com/thing:4948591). *Finishing* - Basic finishing can be done with just acrylic paint applied with a brush or even using a felt pen. - For a pro finish I use the following: - Rough sanding of the model - Apply UV resistant epoxy resin witha brush - Fine grain sanding - Acrylic paint applied with airbrush - Clear acrylic coating applied with airbrush ----------------------------------------------------------------- If you like that model please consider making a small donation to the "[Cartable & Sparadrap](https://cartablesparadrap.wixsite.com/cartableetsparadrap/faire-un-don)" charity supporting school for children in Toulouse hospitals. Thanks :-)
Statistics
Likes
61
Downloads
0