Smartphone Stand - Super Simple, Easy To Print Phone Holder
Description
This model answer the need for a very simple design. The holes for the cable are small enought that no support is needed. Make sure to have good adhesion for the first layer. I printed at 50 mm/s with eryone black 1.75 pla and had no issues. If you have a beefy cable connector you might encounter clearance issues right below the rectangolar hole. So I made an higher version. Obviously you can print this one if you need an higher stand in general. The stand is 60 mm wide and rises your phone by 4 cm (5 cm for the higher model). Leave comments and suggestion.
Statistics
Likes
34
Downloads
0