Build plate holder for Anycubic Wash & Cure 2
Description
Build plate holder for Anycubic Wash & Cure 2. I recently had issues with larger prints made with the Anycubic Photon Mono (not even close to the largest SLA printers available). The wire dedicated to holding the build plate inside the Wash basket of the Anycubic Wash & Cure 2 eats quite a bit of the build plate (length and width alike); as a result, larger prints either don't fit at all, or have to be resting on the wire itself (with flat enough prints), which is obviously far from ideal. I had already "reworked" the wires of the basket to fit earlier prints, but this time I needed something better. This little tool can be set on top of the basket handles inside the Wash bucket with the build plate held at the bottom. With the wash bucket filled to the max, the build plate should dip into your solution about as much as if your resin vat were to be full with the build plate lowered in it (leveling screws are kept out). This way, you can keep cleaning your print and your build plate at the same time. *I've also had good success removing prints from the build plate post-wash (seems a lot easier), hence the reason for making this tool.* *I do not own the Wash & Cure v1, I cannot say for sure if the basket is the same, or if this piece will fit. If someone can try it and leave a comment, I'm sure other owners would appreciate it.* [Buy me a coffee](https://www.buymeacoffee.com/Nerivec)
Statistics
Likes
8
Downloads
0