Dremel 395 chop drop saw brackets
Description
Additional bracket, '2nd-Guide-OC.stl' that holds around the middle of a Dremel 395 to support weight and give better stability. Uses 5mm bolt to tighten the clamp. Remixed from GreaseMonkey88's "Rod and Tube Cutter for Dremel", 'Guide.stl' from https://www.thingiverse.com/thing:3323294 is used screwed onto Dremel from opposite direction, and needs small amount of clearancing to screw further onto the nose of the Dremel. (Props to GreaseMonkey88, am having difficulty adding "remixed from" link... their Guide.stl is the basis for this remix) 10mm rod or threaded rod then goes through both brackets, and is supported on a board or bench using two '10mm-rod-guide.stl'. May need to run 10mm drill through the holes to size them.
Statistics
Likes
10
Downloads
0