Fan duct for the Anycubic Mega
Description
This fan duct is to use a 5015 fan in the Anycubic Mega, and have a simmetrical air flow around the nozzle. I printed the part which I based the remix and had some issues: the fan did not fit well (the relief on the underside for a snap in the fan did not match my fan), and the air outlets of the duct were too close to the heater block. This remix addresses these two situations. *****************UPDATE OCT 5, 2021************************** I am testing a new duct, and if succesful, I will post the new one and the results. As of now, it seems that this duct (and probably some other long and complext ducts) tend to constrain the air flow too much. It looks like that the smaller (the duct) the better. I have still a couple of tests to do, but in the meanwhile, I do not recommend printing this part. ************************************************************************* Update May 6, 2021 Fan duct tabs reinforced (2.0mm to 2.4mm thick) Opening for the screws is smaller for tighter fit of the M3 screws used (was 4.0mm wide now 3.5), and also a bit smaller in vertical size (I had an issue with the duct colliding with the metal clips that hold the glass to the base structure).
Statistics
Likes
6
Downloads
0