Transparent CTC 3D Printer Filament Tube Holder
Description
I Made These For My Transparent Acrylic Case Ctc Printer That I Got From Ebay In February 2014.. It'S Been A Great Printer, But It Had No Place For Filament Tubes To Mount.. These Pieces Keep The Filament Tube Farther Back And Higher Than Usual Which Allows The Use Of Bigger Spools Of Filament Such As The Triple Thick Spools For Pushplastic.. You'Ll Need To Print Out 2 Of These Pieces.. One For Each Side.. They Clip On Tight But I Also Use A Tiny Bit Of Clear Packing Tape To Make Sure They Don'T Go Anywhere.. You Can See That In The Photo.. If Your Filament Tube Is A Little Too Small For The Opening Just Put A Little Scotch Tape Around Your Tube Till It Fits Tight. I Have Tubes Here That Fit Tight And Some That Require Some Tape To Fit Tight.. Note..This Will Not Fit A Ctc Case With A Wooden Frame.. For A Wooden Frame Ctc Try This.. Http://Www.Thingiverse.Com/Thing:678542
Statistics
Likes
25
Downloads
0