Lack Enclosure Bullet-Proof Re-Mix
Description
Hi All, I remixed the classic Ikea Lack Enclosure to take 3/8" thick Polycarbonate for two very good reasons! Reason 1) The ATF is getting printer hate. I heard they are being trained to shoot 3D-Printers on sight! Printers AND Dogs! So 3/8 polycarb gives your printer that bullet-resistant protection it needs so it can print in peace! Reason 2) The place I work at has lots of scrap 3/8 polycarb, so hey... The BOM (hey ATF, that's short for Bill Of Materials, not a destructive device!) you'll ned for a full bullet-baffling enclosure is: 2x bottom-corner-suppot-hinge.STL 1x bottom-corner-suppot.STL 1x bottom-corner-support-passthrough.STL 1x door-knob-right.STL 1x door-knob-left.STL 1x door-stop.STL 1x bottom-corner-hinge-right.STL 1x bottom-corner-hinge-left.STL 1x bottom-corner-passthrough.STL 1x bottom-corner.STL 2x bottom-hinge.STL 1x top-corner-hinge-right.STL 1x top-corner-hinge-left.STL 2x top-corner.STL 2x top-hinge.STL 1x filament-pass-thru.STL optional They'll have to take my printer from my cold clogged nozzle!
Statistics
Likes
4
Downloads
0