Wemos D1 Mini OLED Wedge (Updated Design)
Description
I printed one of the original models made by jurassic73 https://www.thingiverse.com/thing:4786941 and LOVED it! Total credit for the main unit goes to him. But, I found that it looks like there have been some minor revisions, or maybe just different manufactures, to the Wemos Mini D1 boards since he created his... I made the following modifications to his original design: * I've widened the groove where the wemos board slides in. It was too tight of clearance and not quite in the proper spot for my boards. * I've also widened the slot where the USB port is on the wemos. My guess is that they just switched to a slightly wider usb port or mounted it slighlty different or something. * I made the USB port hole just slightly wider as well since I wasn't making a good connection with the cable I was plugging in. * I removed the screw hole. I found that just a dab of hot glue on the inside was more than enough to hold it together really nicely while making it still really easy to pull apart if needed. * The final revision was a choice I made so that I could add an additional DHT22 or other sensor out the back and that was to include two small holes out the backside of the case. That way I can run a little bundle of wires out the back to a sensor I place some space away from it. I originally tried mounting the DHT right inside the back of the case, but the esp8266 created just enough heat that it would affect it upwards of 10 degrees. Even putting the sensor 1 inch away was enough to get rid of that issue. Since I know not everyone would want that, I've included a version without the two holes as well. Thanks to jurassic73 for the inspiration!
Statistics
Likes
23
Downloads
0