Cheburashka SIMPLE & EASY Ender-3 / CR-10 BMG direct mount with E3D V6 and one or two 5015 blower(s) with BLTouch
Description
*30.05.2021 I replaced the files with updated version:* - Thicker backplate (2mm -> 3mm) - Thicker heatsink hilder - Two holes in the wire hilder plate for convenient cable tie use This is a single piece adapter to upgrade your Creality CR-10 or Ender-3 printing head to direct extruder with BMG and E3D V6. BLTouch offset is 29mm left and 12mm front. You will need: 1. 1x BMG extruder (orientation - right) 2. 1x Short (23mm) extruder motor (overwize the motor will hit the portal) 3. 1x V6 hotend with stock 30mm axial cooler 4. PTFE tube (57mm in length for full metall heatbreak, if your heatbreak is different you will need to measure your tube by your self) 5. 1x or 2x 5015 turbine blower 6.1. 4x countersunk M3x12 screws if no BLTouch 6.2. 2x countersunk M3x12 screws with BLTouch 6.3. 2x countersunk M3x20 screws with BLTouch Blower(s) can be snapped in, screws are optional. Printing: 1. Orientation is as shown on one of the pictures 2. Wall line width 0.4 (larger will mess up the blades inside the fan ducts) 3. Supports are don't needed 4. Shell walls 1.2 mm or more (to make the print harder), top/bottom 3-4 layers 5. Infill 20-25% 6. High temperature material is strongly recommended (ABS or PETG). PLA will melt near hot end. Installation: 1. Disassemble the head to bare cariage. 2. Attach the adapter plate with two M3x10 (or 12) 3. Snap in V6 hotend 4. Insert the 57-mm PTFE tube into the heatsink 5. Attach BMG and the 23mm motor (motor connector can be put on the top side) with 3 screws (screws should be included with BMG) 6. Put hotend wires under the left blower place 7. Snap the blower(s) 8. If you need BLTouch - attach it to the heatsink holder with two M3x6 screws from the bottom 9. Attach heatsink holder with 2x M3 screws: 12 mm if no BLTouch installed or 20 mm if there is BLTouch 10. Calibrate the bed X-axis don't need any adjusting Y-axis may need its limit switch to be moved 1 cm closer
Statistics
Likes
43
Downloads
0