DyzeXtruder Direct-Drive Mount for Ender 3
Description
This is a mount for the DyzeXtruder on the Ender 3. It should work with the ender 3 pro, and v2 as well. It was tested with a DyzeXtruder Pro with a DyzEnd Pro, but it should work for The DyzeXtruder GT as well. The probe mount is a completely separate part. This design leaves two left-most screws available for use, so you have a lot of options for mounting your probe. Print in a high-temp plastic such as Polycarbonate for best results. Required hardware: 4x M3 x 14 (M3 X 16 should work too if you have some m3 washers) 2x M3 x 4 2x M3 Heat set inserts (~5mm OD, ~3mm depth)
Statistics
Likes
2
Downloads
0