Yet another QIDI X-PLUS / X-MAX Ribbon Cable Clip
Description
Remixing HumeBeams back clip idea, but with cable slipping out the bottom of the clip. HumeBeams Feet for clipping into the cover slots were remixed and re-spaced (5.75mm spacing), and the rest of the clip is new This clip allows cover to be pulled straight up easily. Pull the lever out 1-2mm to release the ribbon cable. Print on it's side with support between the feet (as per diagram in "QIDI X-Plus X-Max Ribbon Cable Bracket by humebeam ") Printed in PLA+, has enough flex. Post-printing, just needs sharp edges smoothed. Note: with any back clip, on the X-PLUS, when the carriage moves to the back left corner, the cable may bunch up. Also if Extruder cooling duct has been installed,more warm air will be directed onto the ribbon cable, effects unknown.
Statistics
Likes
8
Downloads
0