Dragon Dice Tower (resin printer split)
Description
I liked the design of the original Dragon Dice Tower, but couldn't remotely hope to fit it on my resin printer. As such I split it into five pieces + the roof, which was just enough to fit while keeping it at 100% scale. Most of the pieces can be printed at relatively sane angles, but for my printer the bottom tower section had to be set at an almost perfect 90% angle to fit. If you have a larger resin printer this shouldn't come up as an issue, but if not make sure you have your resin settings dialed in as much as possible.
Statistics
Likes
1
Downloads
0