UniFi US-8-150W - Change power supply EPP-150-48
Description
Bei meinem Unify Switch US-8-150W ist das Netzteil ausgefallen, darum habe ich nach einem Ersatz gesucht. Das EPP-150-48 passt perfekt, ist aber von den Maßen her deutlich kleiner als das Original. Darum habe ich diese Halterung konstruiert, wichtig war, wenig Material und am besten keine Zusätzlich schrauben. Es wird nur 1 zusätzliche Unterlagscheibe benötigt. Achtung: - Beide Originalstecker müssen/sollten um 2 Pins gekürzt werden. - Auf der Seite vom Netzteil zum Board müssen die Pins getauscht werden, (schwarz und rot), sodass plus und minus der Beschreibung des Netzteils entsprechend korrekt sind. Ich hab das mit einem kleinen Schraubenzieher gemacht. EN: The power supply failed on my Unify Switch US-8-150W, so I was looking for a replacement. The EPP-150-48 fits perfectly, but the dimensions are much smaller than the original. That's why I constructed this bracket, important was, little material and best no additional screws. Only 1 additional washer is needed. Attention: - Both original connectors must/should be shortened by 2 pins. - On the side from the power supply to the board, the pins must be swapped, (black and red), so that plus and minus are correct according to the description of the power supply. I did this with a small screwdriver.
Statistics
Likes
5
Downloads
0